Basic Troubleshooting - Nonin CO-Pilot H500 Quick Start Manual

10 Long Term Storage Mode
1
2
3

11 Basic Troubleshooting

Sensor Not
Connected to
Signal Processor
Check that sensor is
plugged into signal
processor and sensor
lock is engaged
Cannot Connect to
Signal Processor
Check that signal
processor is on,
battery is charged,
and in range of
display
To place the display into long term storage
mode, press and hold the On/Off, Sleep button
on the display (Figure 2) until screen prompt
appears
Choose "Power Off" on display screen.
Screen will go black, display is now in
long term storage mode
To place the signal processor
into long term storage mode,
press and hold the on/off button
on the signal processor until
all lights flash simultaneously.
Signal processor is now in long
term storage mode
Sensor Fault
Sensor may be
inoperable, try
another sensor
Error Code
Refer to Operator's
Manual
Press and hold button to
place Signal Processor in
long term storage mode
Figure 5
Inadequate
Signal
Ensure sensor is
properly applied
to patient
Page 7 of 9
CO-Pilot User Guide
PN 114100-001-01