Initial System Setup - Nonin CO-Pilot H500 Quick Start Manual

03 Initial System Setup

1
2
3
4
5
04 Taking a Measurement with CO-Pilot
1
2
3
4
5
Charge display and signal processor
per instructions in Section 9
Press and hold On/Off button on signal
processor until green LEDs blink on and blue
Bluetooth LED begins to blink
Press and hold On/Off,Sleep button on display
until screen turns on
Connect sensor to signal processor and
engage sensor lock (Figure 1)
System is now ready to take a measurement
or to be put into Sleep Mode for future use
Figure 1
Activate the display from sleep mode by briefly
pressing the On/Off, Sleep button on the right
side of the device (Figure 2)
When the display is activated, it will
automatically be connected to the signal
processor and the sensor will turn on
If the signal processor is not
automatically activated, press and
hold down the On/Off button on the
signal processor
Place the sensor on the patient
according to sensor instruction
When operation is complete, briefly press the
On/Off, Sleep button on the display to end the
session and put device into Sleep Mode; signal
processor will enter Sleep Mode automatically
Press On/Off,
Sleep button
to activate
display
Figure 2
Page 4 of 9
CO-Pilot User Guide
PN 114100-001-01