Energetics ET 1070 Assembly Manual page 10

1. Locate the Console Mast (10) and Console Mast Cover (50) and slide the Cover onto the Mast as far
as it will go. Make sure the Console Mast Cover (50) is facing the correct way.
2. At the top opening of the Main Frame (1) of the elliptical is a Computer Cable (37). Unravel and
straighten out the Computer Cable (37) and feed it into the bottom of the console mast tube (10)
and out of the top opening.
3. Install the Console Mast (10) into the receiving bracket in the top of the Main Frame (1). Put the 4pcs
of 5/16"x 23 x1.5T Flat Washers (125) onto the 4pcs of 5/16" x 15m/m Hex Head Bolts (88) and the
2pcs of 5/16" x 23 x 2T Curved Washers (129) onto the 2pcs of 5/16" x 15m/m Hex Head Bolts (88).
Install, and hand tighten by using the 12m/m Wrench (136).
NOTE: There is an electrical wire running through the Console Mast Tube (10). Be careful not to
damage or pinch this Computer Cable (37) during this procedure.
4. Cut off the wire tie and separate the Computer Cable (37) then plug it in together with two
Handpulse W/Cable Assemblies (41) onto the bottom of Console Assembly (36). Secure the Console
Assembly (36) on the console holding plate with 4pcs of M5x10m/m Phillips Head Screws (98) by
tightening them with Combination M5 Allen Wrench & Phillips Head Screw Driver (135).
5. Insert two Rail Tubes (17) into the Frame Base and secure with 2pcs of 3/8" × 2-1/4"_Button Head
Socket Bolts (97), 2pcs of 3/8" × 19 × 1.5T_Flat Washers (123) and 2pcs of 3/8" × 7T_Nyloc Nuts (115)
by using 13.14m/m_Wrench (137) and Combination M5 Allen Wrench & Phillips Head Screw Driver
(135).
6. Lay Rail Assembly (13) between Rail Tubes(17), and secure with four 3/8" × 2-1/4"_Button Head
Socket Bolts (97) and 4pcs of 3/8" x 2T Split Washer (167) and 4pcs of 3/8" × 23 × 2T_Curved Washers
(130) by using Combination M5 Allen Wrench & Phillips Head Screw Driver (108).
10