Table of Contents
Advertisement
Charging Spare Battery Packs
The Base Unit of your ANA 9500 is equipped with a Battery
Charger for charging an Optional Spare Battery Pack.
1. Position the Battery Pack
so the inner side is facing
toward the top of the
Base Unit.
2. Slide the Battery Pack into
the Charging Compartment
until it clicks into place.
( Note: The Battery Pack
Charging Compartment has
a latch that keeps the
Battery Pack in place during
charging.)
Make sure the BATTERY CHARGE LED lights. If the
BATTERY CHARGE LED does not light, check to see that the AC
Adapter is plugged in, and that the Battery Pack is seated into the
Charging Compartment.
Note: Charge the Standard 400 maH Battery Pack without
interruption for 6-8 hours. Charge the optional 730 maH maH
Battery Pack without interruption for 8-10 hours.
When charging is complete, press down on the latch to remove the
Battery Pack for use. Or, if you don't need the Battery pack immediately,
leave it in the Charging Compartment (It will not overcharge.)
Low Battery Indicator
When the Battery Pack in the
Handset is low and needs to be
charged, you will see a message on
the display.
On a Call
Only the TALK button operates.
Handset beeps once every 3 seconds
Complete your call as quickly as possible
Replace Battery pack within 20 seconds
to continue call.
Return the Handset to the Base Unit for charging or replace the
Handset Battery Pack with another charged Battery Pack.
In Standby Mode
None of the buttons operate.
Handset beeps once.
Cannot make call.
Replace Battery Pack before making a
call.
12
+
–
DC IN 10V
LINE OUT
LINE IN
AC ADAPTOR
Tone
Pulse
Advertisement
Table of Contents
