Using Your Ana 9500 Handset; Ana 9500 Handset Controls - Uniden ANA 9500 Operating Manual

Using Your ANA 9500 Handset

Note: Operation of the ANA 9500 is performed using the Handset
off the Base Unit. The exceptions are charging the Handset Battery
Pack, and terminating a call with AutoStandby. The Base Unit is used
to place a call on HOLD, or to Page the Handset. These operations
are discussed in the Section: "Using Your ANA 9500 Base Unit".

ANA 9500 Handset Controls

Handset Earpiece
Volume (During a Call
Press VOL on the side of
the Handset to select a
loud or soft Earpiece
volume level.
R/VOL
L
L
MUTE
Ringer Select (Standby
Mode)
Press VOL on the side of
the Handset to select from
RING HIGH
Note: You get a vibrator
alert instead of a ring tone
when you set the Ringer
Volume to RING OFF.
14
Mute
RING LOW