Low Battery Indicator; Setting The Pulse/Tone Switch; Adjusting Ringer Controls; Adjusting Handset Receiver Volume - Uniden XC815 Owner's Manual

To Avoid this Memory Effect
At least once a month, operate the unit until the
"Battery Low" indicator appears. Then recharge
the battery for a full 15 - 20 hours. Avoid putting
the handset back in the base after using the phone
for a short time. This could cause "topping off"
the charge.

Low Battery Indicator

When the battery
pack in the handset is
very low and needs to
be charged, the
talk/batt low
LED flashes.
If the talk/batt low LED begins to flash, the phone is
programmed to eliminate its functions to save
power. The table below describes how to return
your phone to normal operation.
During a Call
T
Only the button operates.
The handset beeps and the
talk/batt low LED flashes once
every 3 seconds.
Complete your call as quickly
as possible.
Return the handset to the base
for charging.
Note: Allow 15 to 20 hours without any
interruption for the handset to fully recharge.

Setting the Pulse/Tone Switch

Be sure the
PULSE/TONE switch
is in the TONE
position.
In Standby Mode
None of the buttons will operate.
The handset talk/batt low LED
flashes once every 3 seconds.
You will not be able to make a
call.
Return the handset to the base
for charging.
Note: Most phone systems are tone dialing. Check
with your local phone company if you are not
sure whether your system is tone or pulse dialing.

Adjusting Ringer Controls

To adjust the ringer volume of your handset,
G
press when the phone is not in use.
You can also select one of two different ringer
tones for the handset.
G
Press to select a different ringer tone when
the phone is not in use.

Adjusting Handset Receiver Volume

Volume settings are "normal" and "high." When
the handset is first picked up, the volume will be
at the "normal" setting. Pressing the
change the volume to "high." This can be done
during a call.

Automatic Digital Code Security

To avoid unauthorized calls on your phone, a
digital code feature was added to all XC800 Series
phones. This digital code is shared only between
the handset and base. The code is set
automatically when you first use the phone.
To change the digital code, be sure the handset is
on the base, then:
1. Press the page/find button on the base.
2. After the handset stops beeping, remove it
from the base.
3. Wait 5 seconds, then place the handset on
the base.
4. The status LED blinks to indicate that the digital
security code is set.
If the base loses power while the handset is off
the base, the digital code may be erased. When
this happens, the handset will not function. To
reestablish communication between the handset
and base:
1. Restore power to the base.
2. Place the handset back on the base.
3. The status LED will blink to indicate that the
digital security code is set.
8
V
will