Trouble Shooting - Uniden ANA 9500 Operating Manual

If your ANA 9500 Cordless Telephone is not performing to your
expectations, please try these simple steps. If you are still unable to
resolve the problems, contact your PBX Administrator.
Note: Do not attempt to service this unit yourself. All service must be
done by qualified service personnel.
Problem
Charge light won't come
on when Handset is
placed in Base Unit.
Conversation
interrupted frequently.
Warning tone and NO
SERVICE message.
Handset doesn't ring.

Trouble Shooting

Make sure the AC Adapter is plugged into
the Base Unit and wall outlet.
Make sure Handset is properly seated in
Base Unit.
Make sure the Nickel-Cadmium Battery
Pack is properly placed on the Handset.
Make sure that the charging contacts on
the Handset and Base Unit are clean.
Make sure that the Base Unit antenna is
fully vertical.
Move closer to the Base Unit.
Check for LOW BAT warning.
Move closer to the Base Unit.
Nickel-Cadmium Battery may be weak.
Charge the Battery Pack for 8-10 hours.
Check the Ringer Alert setting. It may be
on RING OFF without the optional
Vibrator Alert installed.
Make sure the Base Unit antenna is fully
vertical.
The Handset may be too far away from
the Base Unit.
30
Suggestion