Common Issues
If your phone is not performing to your expectations, please try these simple steps fi rst. If these steps do not
solve your problem, please visit Uniden's customer support page at www.uniden.com.au (Australian model)
or www.uniden.co.nz (New Zealand model).
Symptom
The charge LED won't
illuminate when the handset
is placed in the cradle.
The audio sounds weak.
Can't make or receive calls.
Severe noise interference.
DECT6035, 6035+1 OM.indb 50
DECT6035, 6035+1 OM.indb 50
•
Make sure the AC adapter is plugged into the base or the charger (if you have
more than one handset) and wall outlet.
•
Make sure the AC outlet is not connected to a wall switch.
•
Make sure the handset is properly seated in the cradle.
•
Make sure the charging contacts on the handset are clean.
•
Move the handset and/or base away from metal objects or appliances.
•
Make sure that you are not too far from the base.
•
Make sure that you are not too far from the base.
•
Make sure the line is not in use. If an outside call is already using a line, you
cannot use that line to make another outside call.
•
Make sure your handset is registered to the base.
•
Check both ends of the base telephone cord.
•
Make sure the AC adapter is plugged into the base and wall outlet.
•
Disconnect the AC adapter and reconnect.
•
Keep the handset away from microwave ovens, computers, remote control toys,
wireless microphones, alarm systems, intercoms, room monitors, fl uorescent
lights, and electrical appliances.
•
Move to another location or turn off the source of interference.
50
Suggestion
8/8/07 3:25:47 PM
8/8/07 3:25:47 PM