Resetting The Handset Without The Base; Traveling Out Of Range - Uniden 6035 + 1 Owner's Manual

Resetting the Handset Without the Base

If your original base is not available for some reason, you can still reset the handset and use it with another base.
1) Press and hold [ ] and [#] for at least fi ve seconds.
2) Move the cursor to select BASEUNAVAILABLE and then press
3) Select the base which you want to de-register from, and then press
4) Move the cursor to select YES, and then press
handset deletes its own base information without contacting the base. The handset displays HANDSET NOT
REGISTERED-PLACE HANDSET ON BASE TO REGISTER. SEE YOUR OWNER'S MANUAL FOR HELP.
5) Register the handset to the new base (see Registering Accessory Handsets on

Traveling Out of Range

During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the
base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection
for thirty seconds after the handset goes out of range. If you move the handset back within range of the base within
thirty seconds, press [ /Flash] or [
Note: If it is set to automatically select the available base, the handset will begin searching for another base thirty
seconds after going out of range. (see Selecting the Base on page 21).
DECT6035, 6035+1 OM.indb 49 DECT6035, 6035+1 OM.indb 49
[Menu/Select]. You hear a confi rmation tone, and the
] to pick up the call again.
49
[Menu/Select].
[Menu/Select].
page 20).
8/8/07 3:25:46 PM 8/8/07 3:25:46 PM