Installing The Belt Clip; Connecting The Base And Charging The Handset - Uniden 6035 + 1 Owner's Manual

Installing the Belt Clip

Line up the holes on each side of the handset. To attach the belt clip, insert into
the holes on each side of the handset. Press down until it clicks.
To remove the belt clip, pull either side of the belt clip to release the tabs from
the holes.

Connecting the Base and Charging the Handset

1) Route the AC adapter cord through the "LOOP" of base's back as shown.
2) Connect the AC adapter to the DC IN 9V jack.
CAUTION: To avoid risk of fi re and shock, only use the
Uniden AAD-041S AC adapter.
3) Connect the AC adapter to a standard 240V AC wall outlet.
DO NOT use an AC outlet controlled by a wall switch.
4) Place the handset in the base with the LCD screen facing
forward.
5) Make sure that the charge LED illuminates. If the LED does
not illuminate, check to see that the AC adapter is plugged
in and the handset makes good contact with the charging
contacts.
6) Charge your handset at least 15 to 20 hours before plugging
into the phone line.
DECT6035, 6035+1 OM.indb 14 DECT6035, 6035+1 OM.indb 14
To DC IN 9V
14
Route the cord.
To AC outlet
AC adapter (supplied)
8/8/07 3:25:40 PM 8/8/07 3:25:40 PM