Huawei UPS5000-S Series User Manual page 99

UPS5000-S-(40 kVA-200 kVA)
User Manual (IP42, 40 kVA Power Modules)
Figure 4-13 IP settings
IP address allocation


Table 4-11 Bitwise AND operation example
-
PC IP address/UPS IP
address
Subnet mask
(255.255.255.192)
Bitwise AND operation
result
After you restart the device, IP address allocation changes back to Manual. The IP address is set to the
IP address set previously.
Issue 03 (2020-01-10)
If the MDU is directly connected to a computer, the IP address can only be allocated
manually. The IP addresses of the MDU and computer must be in the same network
segment, and must be different.
If the MDU is connected to a computer through a LAN switch or router with the DHCP
function, the IP address can be allocated manually or automatically. Manual allocation is
used by default.
− Manual: Check that their IP addresses are two different values on the same network
segment. Set the UPS IP address to be in the same subnet as the PC IP address.
Perform the bitwise AND operation for the UPS IP address and the PC IP address
with the subnet mask respectively. If the operation results are the same, the two IP
addresses are in the same subnet.
AND operation rule: 1 AND 1 = 1, 1 AND 0 = 0, 0 AND 1 = 0, 0 AND 0 = 0. That
is when the corresponding bits are both 1, the result is 1. In other cases, the result is
0.
− Automatic: The MDU automatically searches for available IP addresses in the
connected network. Ensure that the MDU and PC are on the same network segment.
Copyright © Huawei Technologies Co., Ltd.
PC IP address
(182.98.225.125)
10110110.01100010.111000
01.01111101
11111111.11111111.111111
11.11000000
10110110.01100010.111000
01.01000000
4 User Interface
UPS IP address
(182.98.225.112)
10110110.01100010.111000
01.01110000
11111111.11111111.111111
11.11000000
10110110.01100010.111000
01.01000000
91