Huawei UPS5000-S Series User Manual page 127

UPS5000-S-(40 kVA-200 kVA)
User Manual (IP42, 40 kVA Power Modules)
Input Settings
Output Settings
Issue 03 (2020-01-10)
Item Description
is set to Enable, the control chip
RAM working status is checked
regularly. If this parameter is set
to Disable, regular check is
disabled.
Record time Indicates the time for storing
after fault
fault data after the UPS
experiences a fault. The default
value is 0 ms, which means that
the data during 20 ms before the
fault occurs is recorded. If the
value is set to 40 ms, it means
that the data during 20 ms before
the fault occurs and the data
during 40 ms after the fault
occurs are recorded, and the like.
Collect real- If this parameter is set to Enable,
time site one waveform can be stored
waveform manually.
BCB trips in If this parameter is set to Enable,
case of EOD
the BCB will trip in case of
EOD.
Item Description
Input The value of Input adaptability
adaptability can be Strong or Weak. Strong
input adaptability applies to the
D.G. or input sources whose
input current has high frequency
oscillation. In this mode, the total
distortion of the input current
waveform (THDi) is poor, but
the system is stable. Weak input
adaptability is suitable for mains
and AC input sources.
Item Description
Zero display If this parameter is set to Enable,
with no load the output current is displayed as
output
0 when no load is output. The
output load rate is displayed as
Copyright © Huawei Technologies Co., Ltd.
4 User Interface
Default Value Value Range
0 ms 0 ms, 20 ms, 40
ms, 60 ms, 80
ms
Disable Disable, Enable
Enable Disable, Enable
Default Value Value Range
Strong Strong, Weak
Default Value Value Range
Enable Disable, Enable
119