Huawei UPS5000-E-400K Series User Manual page 173

UPS5000-E-(400 kVA-600 kVA)
User Manual (60 kVA Power Modules)
Step 4 View the system running diagram on the MDU to check that the UPS is working in bypass
mode.
----End





Online Startup
Step 1 Insert a WiFi module into the USB port on the MDU.
Step 2 Enable the mobile phone WLAN, search for the UPS WiFi signal, and connect to the WiFi
signal. The default value of SSID is UPS_WIFI.
Step 3 Open the Service Expert app on the mobile phone.
Step 4 On the home screen of the app, tap Startup to access the Set Startup screen.
Issue 05 (2019-12-24)

If dry contact signals are connected to the system, choose System Info > Settings > Dry Contact
Set and check that the connected dry contacts have been enabled and that the disconnected dry
contacts have been disabled.
The Service Expert
Android. User interfaces displayed in this document correspond to the app version
V100R001C00B055 and are for reference only.
For offline startup, enter the barcode and the verification code on the mobile phone app.
The app automatically generates a startup password for the UPS. Then enter the password
on the MDU screen to start the UPS.
For online startup, activate the startup password on the mobile phone app to start the UPS.
If the initial startup verification passes, startup verification is not required afterwards.
After factory settings are restored, re-verification for startup is required.
The initial WiFi password is Changeme by default. You can change the password by choosing System
Info > Settings > Comm Settings > WiFi Settings on the MDU.
Copyright © Huawei Technologies Co., Ltd.
app can be downloaded from Google Play and can run on
5 Operations
165