Supplementary Data; Radio Approval - Pilz PSEN cs6.11n Operating Manual

PSEN cs6.11n

Supplementary data

Radio approval

USA/Canada
VT8-PSENCS5
FCC ID:
IC: 7482A-PSENCS5
FCC/IC-Requirements:
This product complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standards.
Operation is subject to the following two conditions:
1) this product may not cause harmful interference, and
2) this product must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this product not expressly approved by Pilz may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Le présent produit est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) le produit ne doit pas produire de brouillage, et
(2) l'utilisateur de le produit doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Order reference
System
Product type
PSEN cs6.11n/PSEN
cs6.11 M12
PSEN cs6.11n 1switch
PSEN cs6.11 M12 1actu-
ator
Operating Manual PSEN cs6.11n
1004127-EN-03
INFORMATION
A safety function's SIL/PL values are not identical to the SIL/PL values of
the units that are used and may be different. We recommend that you use
the PAScal software tool to calculate the safety function's SIL/PL values.
Features
Safety gate system with
magnetic latching, fully
coded
Safety switch, fully coded,
with magnet
Actuator, coded, with mag-
net
Connection type
5-pin M12 connector
5-pin M12 connector
Order no.
542 113
542 163
542 181
26