Table of Contents
Advertisement
3-1 FRAME ASSEMBLY 11' THROUGH 27'
3-1.1
No assembly is needed for the 850 Fin-
isholl frame. However, it needs to be placed
on stands approximately 36" high in an open
level area. If your Finisholl is equipped with
frame extensions, see Section 3-4 for
proper installation procedures.
3-2 FRAME ASSEMBLY 30' THROUGH 35'
IMPORTANT
READ ALL SAFETY PRECAUTIONS AT THE
FRONT OF THE SECTION BEFORE ATTEMPT-
ING ANY OF THE FOLLOWING PROCEDURES.
IMPORTANT
SEE FIGURE 3-1 FOR PART NAMES.
3-2.1
Place frame halves on stands approxi-
mately 36" high.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE PARTS
INTO POSITION.
3-2.2
Bolt frame halves together using 3/4-10
X 2-1/2 screws and lock nuts. (See Figure
3-1).
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE PARTS
INTO POSITION.
3-3
Advertisement
Table of Contents
