Table of Contents
Advertisement
ITEM
Radius rod
1
Pivot bracket (mast)
2
Pivot block (rockshaft)
3
Rockshaft bearing blocks (frame)
4
Rockshaft bearing blocks (wings)
5
Walking beams
6
Disc gang bearings
7
Disc rockshaft bearing blocks
8
Basket bearings ( not shown)
9
Ratchet jacks (disc adjust)
10
Wheel bearings
11
4-8 LUBRICATION
4-8.1
The flowing table specifies the number
and the period of lubrication points on the
850 Finisholl. Proper maintenance of your
machine will, under normal operating condi-
4-9 STORAGE
4-9.1
The service life of the Finisholl will be
extended by proper off-season storage prac-
tices. Prior to storing the unit, complete the
following procedures:
a. Completely clean the unit.
b. Inspect the machine for worn or defective
parts. Replace as needed.
c. Repaint all areas where the original paint
film is worn off.
GENERAL ASSEMBLY
DESCRIPTION
NO. OF
LUBE
POINTS
2
3
1
2 each
2 each
1 each
1 each
2 each
1 each
2 each
Each
tions, help to keep it operating at or near its
peak performance for an extended period of
time. Proper maintenance is also a condition
of keeping your warranty in good status.
(See Figure 4 -11)
d.
Grease all exposed metal surfaces of
shanks, points and discs.
e. Lubricate each point of the machine as
stated in Section 4-8.
4-9.2
Store the unit in a shed or under a tar-
paulin to protect it from the weather. The
ground tools and tires should rest on boards,
or some other object, to keep them out of
the soil.
INTERVAL (Hours
unless stated)
50
10
10
10
10
50
10
10
10
50
Yearly
4-11
Advertisement
Table of Contents
