Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
The Troubleshooting Guide, shown below, is included to help you quickly locate problems that can hap-
pen using your 850 Finisholl. Follow all safety precautions stated in the previous when making any adjust-
ments to your machine.
PROBLEM
1. FIELD NOT LEVEL BEHIND FINISHOLL
2. DISC GANG STOPS TURNING AND PLUGS.
PROBABLE CAUSE:SOLUTION
A. WING NOT LEVEL WITH MAIN FRAME:
Adjust depth control on wing lift cylinders so that
wings operate at same depth as frame.
Lift cylinders out of phase. Raise Finisholl and hold
hydraulic lever until all lift cylinders are completely
extended.
Extend wing fold cylinders to allow wings to flex over
uneven ground.
B. FINISHOLL NOT LEVEL FRONT TO BACK:
Adjust radius rod to level unit.
Thread nut completely onto leveling rod and lock
with jam nut.
C. DISCS RUNNING TOO DEEP: Adjust discs only
deep enough to cut residue and level ridges.
D. HARROW NOT SET CORRECTLY:
COIL TINE HARROW - Adjust harrow teeth at more
aggressive angle and/or increase spring pressure.
SPIKE TOOTH DRAG HARROW - Adjust harrow up
or down until harrow runs flat.
SPIKE TOOTH SPRING HARROW - Adjust angle of
teeth for more aggressive action and/or increase
spring pressure.
E. UNIT DOES NOT STAY LEVEL WHEN DISCS
ARE RAISED OR LOWERED: Install optional
hydraulic radius rod. See your Landoll dealer for
details.
A. DISCS SET TOO SHALLOW: Increase depth of
disc gangs. Disc should run deep enough to cut
residue.
B. SCRAPERS SET TOO TIGHT: Adjust scrapers
for less spring pressure. Scrapers should apply only
enough pressure to clean damp soil from discs.
C. DISC BLADE WEAR: Disc may be too small. New
blades measure 20".
D. DISC BLADE CONCAVITY: Disc blades should
have 1-5/16" of concavity.
5
5-1
Advertisement
Table of Contents
