Western Digital Ultrastar Data60 Manual page 8

EcoDesign Disclosures
Table 1: Procedure Requirements
T7, T8, T10 Torx Screwdrivers
#2 Phillips Screwdriver
Opening the CMA(s)
Step 1 : Place the CMA(s) into service position.
a. Unlatch the CMA(s) from the rail at the elbow connector by pressing the blue release
button.
b. Swing the CMA(s) away from the enclosure.
c. The arm(s) should be extended away from the enclosure as shown in the following
example.
Powering Down the Enclosure
* Two people required for lifting enclosure; only one required for disassembly
Required Tools
Figure 1: Unlatching a CMA Connector
Figure 2: CMA(s) in service position (Cables not shown)
1. EU EcoDesign Disclosures
1.4 Ultrastar Data60 Disassembly
# of People Required
2 *
Time
Required
2 hours
5