Western Digital Ultrastar Data60 Manual page 16

1. EU EcoDesign Disclosures
EcoDesign Disclosures
1.4 Ultrastar Data60 Disassembly
Figure 14: Removing IOM
Step 14 : Repeat these steps to remove the remaining IOM from the enclosure.
Disassembling the IOMs
Step 15 : Lay one of the IOMs on its side.
Step 16 : Using a T7 Torx screwdriver, remove the four (4) M3 6mm screws from the ends of the IOM:
Step 17 : Lift the bottom edge of the side-panel. Then slide the panel toward the bottom of the IOM
before lifting it upward to remove it from the IOM:
13