Troubleshooting; Failure Display Codes - Samsung NY58J9850WS Service Manual

4. Troubleshooting

4. Troubleshooting

4-1 Failure Display Codes

There are two kinds of error codes. One denotes an oven temperature
sensor error and the other denotes a safety error. Possible error codes
during use can be checked before service.
1 . Touch Clock pad .
2 . Touch the number pads 1,2,3 and 4 . Make sure the Timer and
Warming Drawer are both turned OFF .
3. Touch the Start/Set pad.
4 . Touch the 'Clock' and the 'Touch to Wake-Up' pads at the same time for 2
seconds . Error codes are displayed .
5 . Press the 0 number pad, to display the latest 5 error codes .
If the power is interrupted and the oven turns off, the stored error codes are
deleted .
6. Press the Off/Clear pad to return to normal display mode.
Oven sensor error
FAILURE CODE
Oven Sensor Opened
C-21
Oven Sensor Shorted
C-22
This document can not be used without Samsung's authorization. This document can not be used without Samsung's authorization.
CAUSE
1 . Disconnect electrical Power to the range . Remove the
upper rear cover panel .
Measure the sensor resistance:1080Ω at the room
temperature → If there are any problems, replace the oven
temperature sensor .
(Over 2950Ω)
2 . If there is not any problem with oven temperature sensor,
Please check whether there is a damaged terminal or wire
on harness .
3 . Disconnect the oven sensor connector from the PCB .
Check resistance of oven sensor connector on PCB .
(Normal : 2850Ω)
(Under 930Ω)
SOLUTION
59