Samsung NY58J9850WS Service Manual page 62

4. Troubleshooting
Failure Display Codes
Safety error
Disconnect power and remove the PCB .
* Source Control, Bake, Broil, and Convection relay
checks.(Normal:∞ Ω)
* Check whether there is any damaged parts of the PCB
pattern .
* Measure oven sensor resistance .
(1080Ω at the room temperature)
* Check the oven sensor harness connections at the PCB .
* Check divider switch and wire conneciton .
* Check the Control Relay, Bake and Broil harness
connections to the PCB .
* Make sure the harness connectors are completely
seated in the CN301 , T501 ~ T511 terminals on
the PCB .
This document can not be used without Samsung's authorization. This document can not be used without Samsung's authorization.
"C-21"
* Repair or replace the PCB .
* Solder again if pattern is damaged
or parts are wrong contacted .
* Replace and reconnect the oven
sensor .
* Replace the divider switch .
Convection Relay
62
Source Control Relay
Broil Relay
Bake Relay