Samsung NY58J9850WS Service Manual page 67

4. Troubleshooting
Failure Display Codes
"C-F0"
* Disconnect power .
* Get rid of connector (CN403,CN201) on Assy
display, main PCB .
* Check whether harness connected normally
into CN403,CN201 on assy display, main
PCB .
* Check whether between connector
(CN403,CN201) pin and pin on assy display,
main PCB have a short circuit .
* With replacing assy display, and make set
work .
END
This document can not be used without Samsung's authorization. This document can not be used without Samsung's authorization.
Ok
Ok
Ok
Assy display PCB
CN201
No
* Repair damaged harness or replace .
* Repair the area of circuit having short
Between connector(CN403,CN201) pins
on Assy display, main PCB .
No
* Repair after confirming whether pattern
is Between micom and connector have a
short circuit or get damaged .
No
* Replace assy display, main PCB .
67
CN403
Assy main PCB
END
END
END