Table of Contents
Advertisement
Configuring Web Proxy Settings
To configure the time period for which a wpad.dat file sent to a subscriber is valid, use
this command:
set wpad-timeout seconds
For example, to set the timeout to 800 seconds, type:
sms2000%
Web Proxy Server
Enable Proxy Server Support
When enabled, the SMS2000 will autodetect proxy servers configured on subscribers. A
subscriber may have a proxy server configured with any IP address, but the TCP port on
which her proxy server is configured must be included in the set of ports configured on
the SMS by the set proxy-ports command.
To enable proxy server support, use this command:
set proxy-server on
For example to enable proxy server support, type:
sms2000% set proxy-server on
Disable Proxy Server Support
To disable proxy server support, use this command:
set proxy-server off
For example to disable proxy server support, type:
sms2000% set proxy-server off
Viewing Proxy Server Support Status
To view proxy server support status, use this command:
show proxy-server
TUT Systems, Inc
Subscribers can manually remove a wpad.dat when using Windows
Note:
2000/NT by removing the following file:
C:\WINNT\Temporary Internet Files\wpad.dat
The file all versions of Windows should be named similarly.
set wpad-timeout 800
Note: Changing the proxy server status requires a reboot.
Note: Changing the proxy server status requires a reboot.
Page 92 of 104
P/N 220-06288-20
Advertisement
Table of Contents
Troubleshooting
