System Administration
To delete the SNMP trap recipient, type:
To view the SNMP trap recipient configuration, type:
Troubleshooting Tools
System Information Tools
Setting the System Information Dump
Use the dump-info command to e-mail the status of the system to a specified address
when the SMS2000 has a fatal error.
An e-mail address of the network administrator can be entered, along with an SMTP
server, or the diagnostic information can be mailed directly to the Tut Systems' Customer
Support e-mail address: support@tutsys.com.
To e-mail the status of the system to a specified address when SMS2000 has a fatal error,
use this command:
For example, to configure the e-mail address of Tut Systems' Technical Support to
receive notification of system failures, type:
Setting a Software Watchdog
Use the set soft-watchdog command to enable or disable the software watchdog in order
to get diagnostic builds from the SMS2000. The software watchdog is disabled by
default.
For example, to enable the software watchdog, force a fault condition, and reboot the
SMS2000 to test e-mail sending, type:
TUT Systems, Inc
SMS2000% snmp delete trap-recipient
show snmp trap-recipient
dump-info {recipient_@_server [recipient_server] | off}
dump-info support@tutsys.com itsmail.tutsys.com
sms2000%
The software watchdog should only be enabled if you have configured a
Note:
recipient for diagnostic information with dump-info and are experiencing
problems with the SMS2000.
set soft-watchdog [ on | off ]
sms2000% set soft-watchdog on
Page 40 of 104
P/N 220-06288-20