Chapter4 - System Administration; Configuration E-Mail Settings; Setting The Default Configuration E-Mail - Tut Systems SMS2000 User Manual

System Administration

Chapter4 - System Administration

This chapter describes the system administration activities and commands, including:
•

Configuration E-Mail Settings

•
Configuration and System File Tools
•
Configuring SMTP
•
Configuring NTP
•
Configuring SNMP Polling
•
Connectivity and Testing
•
System Tools
•
Event Tracking
•
System Administration Tools
•
Troubleshooting Tools
•
Subscriber Connectivity Commands
•
Upgrades
Configuration E-Mail Settings

Setting the Default Configuration E-mail

Each time you save a new configuration, the SMS2000 can automatically send an e-mail
with the new configuration to a specified recipient. The set config-mail command allows
you to specify the recipient.
To configure the SMS2000 to send its configuration file to a specified e-mail address
each time the configuration is saved, use this command:
For example, to configure the SMS2000 to send an e-mail with the new configuration file
attached to ted@smith.com, using smith.com as the e-mail server, type:
TUT Systems, Inc
The SMTP server must be the DNS name or IP address of the destination
Note:
mail server. If the IP address is not provided, the server name in the e-mail
address is used, which is normally not the desired behavior.
set config-mail recipient@SMTPserver [SMTPserver]
sms2000% set config-mail ted@smith.com mail.smith.com
Page 25 of 104 P/N 220-06288-20