Disabling Authentication; Setting The Authentication Interval; Bypassing Authentication - Tut Systems SMS2000 User Manual

Authentication
A warning will appear.

Disabling Authentication

Use the auth off command to disable authentication for the current group.
If you use the auth off command with the forcedweb option, when an unauthenticated
subscriber first trys to access the Internet, the subscriber is automatically redirected to the
specified Web page; for example, an ISP's portal page. If the blockall option is also
specified, subscribers cannot use network services, such as FTP and telnet, until this Web
page has been viewed, otherwise only web services are blocked. To disable
authentication for the current group use this command:
For example, to disable authentication for the current group, but send subscribers to the
tutsys.com page, type:

Setting the Authentication Interval

To set the interval used for recurring authentication (in minutes), use this command:
For example, to set the interval between recurring authentications to one hour (60
minutes), type:

Bypassing Authentication

To manually connect a client and bypass authentication, use this command:
For example, to manually connect the user associated with port 3, type:
TUT Systems, Inc
You do not have to specifically enable authentication. Simply adding a
Note:
Web or RADIUS server is sufficient.
auth off [forcedweb authok_url [blockall]]
sms2000% auth off forcedweb http://www.tutsys.com
This is only used when authentication is turned off for the group and
Note:
forced web is enabled.
auth interval {minutes | off}
sms2000% auth interval 60
When authentication is off and a forced web page is enabled, the forced
Note:
web page will be presented to the subscriber at the end of every auth interval.
connect session_id
sms2000% connect 3
This command requires a session id and that authentication is enabled.
Note:
Page 48 of 104 P/N 220-06288-20