Establishing A Connection Via Telnet - Tut Systems SMS2000 User Manual

Initial Configuration
11. Click OK.
12. Set the following parameters in the Settings tab:
•
•
•
13. Click OK to close the dialog box.
14. To save this configuration for the future, select File/Save As and enter the name of
the file for this configuration.
Perform the following steps to log on to the SMS2000:
1. Power up the SMS2000 when the system is finished rebooting (1 to 5 minutes). You
will hear three consecutive beeps when ready.
2. From the Hyperterm Call menu, select Connect.
3. To verify that you have correctly configured your console port, press <Enter>.
If you are still unable to view the Login Display screen, call your Tut Systems
Customer Service representative.
4. Log on using the username "manager" and the password "manager."
Warning Security is a critical component of this system. As the system administrator, it
is your responsibility to manage the security of this system.

Establishing a Connection Via Telnet

Perform the following steps to gain Telnet access to an unconfigured SMS2000 from the
subscriber port:
To connect directly to the subscriber port:
TUT Systems, Inc
Select Terminal keys.
From the Emulation pull-down menu, select Auto Detect.
Set Backscroll buffer lines to 500.
To avoid cutting off a section of the display, set the window to full screen
Note:
size.
•
If the Login Display screen does not appear:
•
Make sure that you entered the correct settings.
•
Verify that you are using the correct cable and that the cable is not
damaged.
•
Check that you have good cable connections and connector.
The password "manager" is the factory default password for the
Note:
SMS2000. You are strongly encouraged to change your initial logon password
as soon as possible to ensure security. For instructions on changing your
password, see the Changing Your Password section of this chapter.
Page 20 of 104 P/N 220-06288-20