Restoring The Default Configuration; Configuring Smtp; Setting The Smtp Server; Deleting The Smtp Server - Tut Systems SMS2000 User Manual

System Administration

Restoring the Default Configuration

To restore the SMS2000 to the default configuration (with no functions configured), use
this command:
For example, to reset the SMS2000 configuration to default, type:

Configuring SMTP

Setting the SMTP Server

The command set smtp-server starts proxying SMTP sends to the specified SMTP
server. Many mail (SMTP) servers reject mail sent from users who are behind a NAT
device. To compensate for this, an ISP can install a mail server that accepts mail from
each SMS2000. When a subscriber wants to send mail, the SMS2000 can automatically
proxy the mail to the ISP's mail server, which can then cleanly forward it to its final
destination. Many SMTP servers do not forward e-mail from hosts outside the local
network. It is recommended that you use a local SMTP server. For example, if you have a
computer with an IP address in the same subnet as the SMS2000 that can send e-mail, use
the SMTP server configured for your e-mail program.
To redirect Simple Mail Transfer Protocol (SMTP) sends to a specified SMTP server, use
this command:
For example, to route all outgoing mail messages through an SMTP server with the IP
address 1.2.3.4, type:

Deleting the SMTP Server

To stop SMTP proxy sends to the specified SMTP server, use this command:
TUT Systems, Inc
sms2000% restore config
You must reboot the SMS2000 for the restored configuration to take
Note:
effect.
set default
sms2000% set default
This command does not change the password.
Note:
set smtp-server {server_name | ip_address}
sms2000% set smtp-server 1.2.3.4
Page 29 of 104 P/N 220-06288-20