Methods Of Installation - Raisecom ISCOM2826 User Manual

(1) 1000M optical interface.
(2) Indicator light for Ethernet optical port
(3) Fixing bolt for installation
Light Color
LNK/ACT Green
Install sub-card
Please follow the following steps when install sub-cards:
Check and make sure that device is not powered on.
Uncover SLOT cover board.
Insert the sub-card along the mental rail into SLOT
Insert the sub-card tightly, then tighten the two screws to fix the sub-card
Connect the sub-card by fiber or cable
5.2.

Methods of installation

Environmental requirements
There are heat exhausting inlets on both sides of ISCOM2826, the inside fans provide
cooling air for internal circuits. To maintain ambient airflow there must be some space
around the two sides or airflow path. The heat exhausting inlets should not be blocked in
case that the airflow can not flow.
Status
ON Ethernet port is Link up
Flicking Ethernet port is transmitting or receiving data
OFF Ethernet port is Link down
12
Raisecom Technology Co., Ltd
Index