Advertisement
11. With the back of the autosampler off the edge of the table or cart. Locate the 4 cap screws located
under the bottom of the autosampler. As shown in figure 1-3.(only one side is shown in picture)
Figure 1-3
12. Notice the holes in the bottom of the tray, these are for access to the 4 cap screws. Using a long 5/32
allen wrench, loosen the 4 screws slightly so that you can move the body of the auto sampler left, right,
front, and back. As shown in figure 1-4.
Figure 1-4
13. Connect communication cable from the computer to COM 1 on the back of the autosampler.
Advertisement
