Advertisement
7.
If the slider doesn't make it to the top or try's to go to far then you will have to adjust the sensor. You
will want the z-drive to go to top with @ 1/8" space between the top and the slider. To adjust the
sensor turn the rotor as shown below and insert allen wrench (3/32) in hole in the top-center. Loosen
set screw inside and turn knob clockwise if the slider is going to far and counter-clockwise if the slider
is not going far enough. Then tighten the set screw and remove wrench and cycle power, and repaet
procedure until the Z-drive rises to desired height.
8.
To align the Asx-510 follow the instructions below.
Advertisement
