Advertisement
9.
Ensure power to instrument is off. Make sure that you have a sample probe in the Z-drive, and racks
on the right and left of the tray. As shown in figure 1-1. There is no need for racks in the 2 middle
sections of the tray.
Figure 1-1
10. Move the back of the unit to the edge of the table or cart (make sure that you have someone hold the
tray section (as shown in figure 1-2) so that the autosampler will not fall) because the back that is
hanging of the edge of the table or cart is heavy. Or you may move it to the corner it will balance on
the corner on the cart but beware the unit could fall if bumped.
Figure 1-2
Advertisement
