Advertisement
1.
If you have an old z-drive on the unit remove it off both the ADX and ASX-510.
2.
Remove the new Z-drive from the package and locate the end with the peek tubing coming out that has
no mounting block attached to it as shown in the picture below.
3.
Pull the peek tubing until fully extended and cut to a 7" length, and curl with a pen as shown above.
4.
Insert the peek tubing into the ADX Z-drive rotor, align rotor so that the clamp is at the 3 o'clock
position as shown below. When peek hits the stop on the rotor hold it tight to the stop and tighten
clamp by tightening the Philips head screw.
Advertisement
