Advertisement
5.
Turn the rotor manually clockwise until the fitting is ready to be screwed in to the ADX. Screw the
fitting into the ADX until tight. Also at this time attach the Z-drive to the asx-510 on the arm tube and
also to the back by putting the peak through the slot around the rotor on the asx-510, you may have to
loosen the clamp to get the peek tubing past it. Once the peak tubing is past the clamp, attach the
mounting block to the back of the asx-510 with 2 thumbscrews, then turn the rotor manually clockwise
till the stop pin hits the stop. Now pull the peek till the slider on the z-drive (the slider on the right
side) almost hits the top. Tighten the thumbscrew. The z-drives should be attached as shown below.
6.
With the Z-drives attached turn the rotor on the ADX counter-clockwise to lower the slider on the Z-
drive. Plug in the power supply to the ADX and cycle the power so that the ADX moves the slider to
the top of the Z-drive as shown in picture below.
Advertisement
