Shutting Down An Aggregate Interface; Restoring The Default Settings For An Aggregate Interface - H3C S7500X Series Configuration Manual

Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Configure the aggregate
interface as an edge
aggregate interface.

Shutting down an aggregate interface

Shutting down or bringing up an aggregate interface affects the aggregation states and link states of
member ports in the corresponding aggregation group as follows:
•
When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
group become Unselected ports and all member ports go down.
•
When an aggregate interface is brought up, the aggregation states of member ports in the
corresponding aggregation group are recalculated.
To shut down an aggregate interface:
Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Shut down the aggregate
interface or subinterface.

Restoring the default settings for an aggregate interface

You can restore all configurations on an aggregate interface to the default settings.
To restore the default settings for an aggregate interface:
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
lacp edge-port
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface or subinterface
view:
interface
route-aggregation
{ interface-number |
interface-number.subnumbe
r }
shutdown
21
Remarks
N/A
N/A
By default, an aggregate interface
does not operate as an edge
aggregate interface.
Remarks
N/A
N/A
By default, an aggregate interface
or subinterface is up.