H3C S7500X Series Configuration Manual page 119

[DeviceC] interface gigabitethernet 1/0/1
[DeviceC-GigabitEthernet1/0/1] port link-type hybrid
[DeviceC-GigabitEthernet1/0/1] port hybrid vlan 100 200 untagged
# Associate GigabitEthernet 1/0/1 with the IP subnet-based VLANs 100 and 200.
[DeviceC-GigabitEthernet1/0/1] port hybrid ip-subnet-vlan vlan 100
[DeviceC-GigabitEthernet1/0/1] port hybrid ip-subnet-vlan vlan 200
[DeviceC-GigabitEthernet1/0/1] quit
2. Configure Device A and Device B to forward packets from VLANs 100 and 200, respectively.
(Details not shown.)
Verifying the configuration
# Verify the IP subnet-based VLAN configuration on Device C.
[DeviceC] display ip-subnet-vlan vlan all
VLAN ID: 100
Subnet index
0
VLAN ID: 200
Subnet index
0
# Verify the IP subnet-based VLAN configuration on GigabitEthernet 1/0/1 of Device C.
[DeviceC] display ip-subnet-vlan interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1
VLAN ID
100
200
Protocol-based VLAN configuration example
Network requirements
As shown in
•
The majority of hosts in a lab environment run the IPv4 protocol.
•
The other hosts run the IPv6 protocol for teaching purposes.
To isolate IPv4 and IPv6 traffic at Layer 2, configure protocol-based VLANs to associate the IPv4 and
ARP protocols with VLAN 100, and associate the IPv6 protocol with VLAN 200.
IP address
192.168.5.0
IP address
192.168.50.0
Subnet index IP address
0 192.168.5.0
0 192.168.50.0
Figure 7:
Subnet mask
255.255.255.0
Subnet mask
255.255.255.0
Subnet mask
255.255.255.0
255.255.255.0
21
Status
Active
Active