H3C S7500X Series Configuration Manual page 61

[DeviceA-GigabitEthernet1/0/2] quit
[DeviceA] interface gigabitethernet 1/0/3
[DeviceA-GigabitEthernet1/0/3] port link-aggregation group 1
[DeviceA-GigabitEthernet1/0/3] quit
2. Configure Device B in the same way Device A is configured. (Details not shown.)
Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Port: A -- Auto port, M -- Management port, R -- Reference port
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Route-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Management VLANs: None
Port
GE1/0/1(R)
GE1/0/2
GE1/0/3
The output shows that link aggregation group 1 is a Layer 3 static aggregation group that contains
three Selected ports.
Layer 3 dynamic aggregation configuration example
Network requirements
On the network shown in
•
Configure a Layer 3 dynamic aggregation group on both Device A and Device B.
•
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Figure 12 Network diagram
GE1/0/1
GE1/0/2
GE1/0/3
Device A
Configuration procedure
1. Configure Device A:
# Create Layer 3 aggregate interface Route-Aggregation 1.
<DeviceA> system-view
[DeviceA] interface route-aggregation 1
# Set the link aggregation mode to dynamic.
[DeviceA-Route-Aggregation1] link-aggregation mode dynamic
# Configure an IP address and subnet mask for Route-Aggregation 1.
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
Status Priority Oper-Key
S 32768 1
S 32768 1
S 32768 1
Figure 12, perform the following tasks:
Link aggregation 1
RAGG1 RAGG1
192.168.1.1/24 192.168.1.2/24
GE1/0/1
GE1/0/2
GE1/0/3
Device B
35