H3C S7500X Series Configuration Manual page 49

•
Source MAC address.
•
Destination MAC address.
•
Source IP address and destination IP address.
•
Source IP address and source port.
•
Destination IP address and destination port.
•
Source IP address, source port, destination IP address, and destination port.
•
Any combination of ingress port, source MAC address, and destination MAC address.
To set the global link-aggregation load sharing mode:
Step
1. Enter system view.
2. Set the global
link-aggregation
load sharing mode.
Setting the group-specific load sharing mode
In Layer 2 aggregate interface view, the switch supports the following per-flow load sharing modes:
•
Source IP address.
•
Destination IP address.
•
Source MAC address.
•
Destination MAC address.
•
Layer 1 MPLS label.
•
Destination IP address and source IP address.
•
Destination MAC address and source MAC address.
•
Layer 1 MPLS label and Layer 2 MPLS label.
To set the load sharing mode for an aggregation group:
Step
1. Enter system view.
2. Enter Layer 2 aggregate
interface view.
Command
system-view
link-aggregation
global load-sharing
mode { destination-ip |
destination-mac |
destination-port |
ingress-port |
source-ip | source-mac
| source-port } *
Command
system-view
interface bridge-aggregation
interface-number
23
Remarks
N/A
By default, the device distributes traffic automatically
based on packet types.
•
Layer 2 frames are load shared based on the
Ethernet type, source and destination MAC
addresses, and source port number.
•
IP packets are load shared based on the
following information:
Source and destination IP addresses.
Source and destination port numbers.
IP protocol number.
•
MPLS packets are load shared based on Layer
1 and Layer 2 MPLS labels, and source and
destination IP addresses.
•
MPLS L2VPN packets terminated on the device
are load shared based on source and
destination MAC addresses.
•
MPLS L3VPN packets terminated on the device
are load shared based on source and
destination IP addresses.
Remarks
N/A
N/A