Setting The Expected Bandwidth For An Aggregate Interface; Configuring An Edge Aggregate Interface - H3C S7500X Series Configuration Manual

For an aggregation group, the maximum number of Selected ports must be equal to or higher than
the minimum number of Selected ports.
Configuration procedure
To set the minimum and maximum numbers of Selected ports for an aggregation group:
Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Set the minimum number of
Selected ports for the
aggregation group.
4. Set the maximum number of
Selected ports for the
aggregation group.

Setting the expected bandwidth for an aggregate interface

Step
1. Enter system view.
2. Enter aggregate interface
view.
3. Set the expected bandwidth
for the interface.

Configuring an edge aggregate interface

This configuration takes effect only on aggregate interfaces in dynamic mode.
To configure an edge aggregate interface:
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
link-aggregation selected-port
minimum min-number
link-aggregation selected-port
maximum max-number
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface or subinterface
view:
interface
route-aggregation
{ interface-number |
interface-number.subnumbe
r }
bandwidth bandwidth-value
20
Remarks
N/A
N/A
By default, the minimum number
of Selected ports is not specified
for an aggregation group.
By default, the maximum number
of Selected ports for an
aggregation group depends on
hardware limitation.
Remarks
N/A
N/A
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided by
1000.