Configuring Digest Snooping; Configuration Restrictions And Guidelines - H3C S7500X Series Configuration Manual

If different PVIDs are required on two connected ports, disable inconsistent PVID protection on the
devices that host the ports. To avoid PVST calculation errors, make sure the following requirements
are met:
•
Make sure the VLANs on one device do not use the same ID as the PVID of its peer port (except
the default VLAN) on another device.
•
If the local port or its peer is a hybrid port, do not configure the local and peer ports as untagged
members of the same VLAN.
•
Disable inconsistent PVID protection on both the local device and the peer device.
This feature takes effect only when the device is operating in PVST mode.
To disable the inconsistent PVID protection feature:
Step
Enter system view.
1.
Disable the inconsistent
2.
PVID protection feature.

Configuring Digest Snooping

CAUTION:
Use caution with global Digest Snooping in the following situations:
• When you modify the VLAN-to-instance mappings.
• When you restore the default MST region configuration.
If the local device has different VLAN-to-instance mappings than its neighboring devices, loops or
traffic interruption will occur.
As defined in IEEE 802.1s, connected devices are in the same region only when they have the same
MST region-related configurations, including:
•
Region name.
•
Revision level.
•
VLAN-to-instance mappings.
A spanning tree device identifies devices in the same MST region by determining the configuration
ID in BPDUs. The configuration ID includes the region name, revision level, and configuration digest.
It is 16-byte long and is the result calculated through the HMAC-MD5 algorithm based on
VLAN-to-instance mappings.
Because spanning tree implementations vary by vendor, the configuration digests calculated through
private keys are different. The devices of different vendors in the same MST region cannot
communicate with each other.
To enable communication between an H3C device and a third-party device in the same MST region,
enable Digest Snooping on the H3C device port connecting them.

Configuration restrictions and guidelines

When you configure Digest Snooping, follow these guidelines:
•
Before you enable Digest Snooping, make sure associated devices of different vendors are
connected and run spanning tree protocols.
Command
system-view
stp ignore-pvid-inconsistency
40
Remarks
N/A
By default, the inconsistent PVID
protection feature is enabled.