Image Configuration; Osd Settings - Speco N32NRE User Manual

Live View Introduction
Ø Add Scheme
Click in area ① to create a new scheme. Click
Configure Scheme
Ø
a) Select a scheme in area ① and then click the screen mode button on the tool bar to set the screen mode of the scheme.
b) Select a camera window in area ② and then double click the camera or group in area ③. The camera or group will be added into the selected
window. One camera in the same scheme cannot repeat. You can click the right-click menu "Clear" in area ② to remove a single camera or click
to remove all the cameras.
c) Click "Apply" to save the settings.
Start Sequence View
Ø
Go to the live view interface and then click
sequence. Double click the sequence view interface to pause the view; double click again to restore the view. Click

5.3 Image Configuration

5.3.1 OSD Settings

Click StartàSettingsàCameraàImageàOSD Settings to go to the interface as shown below. Select the camera, enter the camera name (or double
click the camera name in the camera list to change the camera name), enable or disable the name and time OSDs (if enabled, drag the red name and
time OSDs directly in the image view area to change the OSDs' display position) and select the date and time formats. Click "Apply" to save the
settings.
on the top right corner of the scheme to delete it.
to open a window. Set the dwell time in the window and then click
27
NVR User Manual
to start scheme view in
to stop the view.