Quick Sequence View - Speco N32NRE User Manual

Live View Introduction
① Click "Customize Layout" in the above interface
② Click to add a display mode name and then set the screen mode.
③ Add the cameras and adjust the cameras' display sequence as required.
④ Click under the display mode list.
Method Two:
① Click StartàSettingsàSystemàBasicàOutput Settings to go to the interface and then set the screen mode.
② Double click the camera or camera group in the list to add them to the selected window.
③ Click to save the current display mode (refer to 5.2.4 Scheme View In Sequence for detail configurations). The display mode will be saved
and displayed in the display mode list in the live view interface.
Edit Display Mode
Ø
Click "Customize Layout" tab in the live view interface and then select one display mode in the list. Click
to delete the display mode.

5.2.2 Quick Sequence View

You can start quick sequence view if the scheme has not been created. If the scheme has been created, please refer to 5.2.4 Scheme View in Sequence
for details.
Go to the live view interface and then click
group by group according to the camera number of the current screen mode. Double click the sequence view interface to pause the view; double
click again to restore the view. Click
to pop up a little window. Set the dwell time in the window and then click
to stop the view.
25
NVR User Manual
to edit the display mode name; click
to view the live