Appendix B. Three-Digit Display Numbers; Built-In Self-Test (Bist) Indicators - IBM R/S6000 7012 300 Series Operator's Manual

Appendix B. Three-Digit Display Numbers

This appendix contains lists of the various numbers and characters that may display in the
three-digit display. Determine the type of operation being performed, then use the list for that
type operation.

Built-In Self-Test (BIST) Indicators

100
101
102
103
104
105
106
111
112
113
120
121
122
123
124
125
126
127
130
140
142
143
144
151
152
153
154
160
161
162
163
164
165
166
170
180
182
185
186
187
195
199
BIST completed successfully; control was passed to IPL ROS.
BIST started following Reset.
BIST started following power-on Reset.
BIST could not determine the system model number.
Equipment conflict; BIST could not find the CBA.
BIST could not read from the OCS EPROM.
BIST failed: CBA not found
OCS stopped; BIST detected a module error.
A checkstop occurred during BIST; checkstop results could not be logged
out.
Three checkstops have occurred.
BIST starting a CRC check on the 8752 EPROM.
BIST detected a bad CRC in the first 32K bytes of the OCS EPROM.
BIST started a CRC check on the first 32K bytes of the OCS EPROM.
BIST detected a bad CRC on the OCS area of NVRAM.
BIST started a CRC check on the OCS area of NVRAM.
BIST detected a bad CRC on the time-of-day area of NVRAM.
BIST started a CRC check on the time-of-day area of NVRAM.
BIST detected a bad CRC on the 8752 EPROM.
BIST presence test started.
Running BIST. (Box Manufacturing Mode Only)
Box manufacturing mode operation.
Invalid memory configuration.
Manufacturing test failure.
BIST started AIPGM test code.
BIST started DCLST test code.
BIST started ACLST test code.
BIST started AST test code.
Bad EPOW Signal/Power status signal.
BIST being conducted on BUMP I/O.
BIST being conducted on JTAG.
BIST being conducted on Direct I/O.
BIST being conducted on CPU.
BIST being conducted on DCB and Memory.
BIST being conducted on Interrupts.
BIST being conducted on Multi-Processors.
Logout in progress.
BIST COP bus not responding.
A checkstop condition occurred during the BIST.
System logic-generated checkstop (Model 250 only).
Graphics-generated checkstop (Model 250).
BIST logout completed.
Generic SCSI backplane.
Three-Digit Display Numbers
B-1