Process Supplemental Media Task; Product Topology Service Aid; Run Diagnostics Task; Run Error Log Analysis Task - IBM R/S6000 7012 300 Series Operator's Manual

Process Supplemental Media
Notes:
1. This task is supported in Standalone Diagnostics only.
2. Process and test one resource at a time.
3. Do not process multiple supplements at a time.
Diagnostic Supplemental Media contain all the diagnostic programs and files required to test
a resource. Supplemental media is normally released and shipped with the resource.
When prompted, insert the supplemental media. Then press Enter. After processing has
completed, go to the resource selection list to find the resource to test.

Product Topology Service Aid

This service aid provides enhanced product and order quality. Additional information is
provided in :hdref refid=gen. under :hdref refid=prodtop.
Run Diagnostics
The Run Diagnostics task invokes the Resource Selection List menu. When the commit key
is pressed, Diagnostics will be run on all selected resources.
The procedures for running the diagnostics will depend on the states of the Diagnostics Run
Time Options. The run time options are:
Display Diagnostic Mode Selection Menus
If this option is on, the Diagnostic Mode Selection Menu will be displayed when the
commit key is pressed.
Include Advanced Diagnostics
If this option is on, Advanced Diagnostics will be included.
Include Error Log Analysis
If this option is on, Error Log Analysis will be included. When running Standalone
Diagnostics with Include Error Log Analysis set to Yes, ELA will only be done on the error
that is logged in NVRAM.
Run Tests Multiple Times
If this option is on, diagnostic will be run in loop mode. This option is only valid when
running Online Diagnostics in Service Mode.
Run Error Log Analysis
The Run Error Log Analysis task invokes the Resource Selection List menu. When the
commit key is pressed, Error Log Analysis will be run on all selected resources.
Introduction to Tasks and Service Aids
4-13