Rear Cover Removal And Replacement - IBM R/S6000 7012 300 Series Operator's Manual

Rear Cover Removal and Replacement

Note: All 7012 models do not have rear covers. If your model does have a rear cover, use
the following procedure for its removal and replacement.
Removal
1. Grip the lower-right and lower-left corners and tilt the bottom of the rear cover out about
30 degrees. Refer to the illustration.The cover retainers are located at the lower outside
edges.
2. Pull the rear cover off.
Replacement
1. Attach the top edge of the rear cover.
2. Rotate the bottom of the rear cover to the front and push it into place.
Rear Cover
1-6
Operator Guide
1
2