IBM R/S6000 7012 300 Series Operator's Manual page 131

257
258
259
25c
260
261
262
263
269
270
271
272
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
301
302
303
304
305
B-4
Operator Guide
Attempting a Service mode IPL from Token-Ring specified in the IPL ROM
Devices List.
Attempting a Service mode IPL from Token-Ring specified by the operator.
Attempting a Service mode IPL from FDDI specified by the operator.
Attempting a service mode IPL from FDDI specified in IPL ROM device list.
Information is being displayed on the display console.
No supported local system display adapter was found.
Keyboard not detected as being connected to the system's keyboard port.
Attempting a Normal mode IPL from adapter feature ROM specified in the
NVRAM Device List.
Stalled state - the system is unable to IPL.
Low Cost Ethernet Adapter (LCE) POST executing
Mouse and Mouse port POST.
Tablet Port POST.
10/100Mbps MCA Ethernet Adapter POST executing
Auto Token-Ring LANstreamer MC 32 Adapter
Video ROM scan POST.
FDDI POST.
3com Ethernet POST.
Keyboard POST executing.
Parallel port POST executing.
Serial port POST executing.
POWER Gt1 graphics adapter POST executing.
POWER Gt3 graphics adapter POST executing.
Token-Ring adapter POST executing.
Ethernet adapter POST executing.
Adapter card slots being queried.
POWER GT0 Display Adapter POST.
IOCC POST error (irrecoverable).
Standard I/O POST running.
SCSI POST running.
7012 DBA disk POST running.
IOCC bad TCW SIMM in slot location J being tested.
Graphics Display adapter POST, color or grayscale.
ROM scan POST.
System model number does not compare between OCS and ROS
(irrecoverable).
Attempting a software IPL.
IPL ROM passed control to the loaded program code.
Flash Utility ROM test failed or checkstop occurred (irrecoverable).
Flash Utility ROM: User prompt, move the key to the service position in
order to perform an optional Flash Update. LED 302 will only appear if the
key switch is in the secure position. This signals the user that a Flash
Update may be initiated by moving the key switch to the service position. If
the key is moved to the service position then LED 303 will be displayed, this
signals the user to press the reset button and select optional Flash Update.
Flash Utility ROM: User prompt, press the reset button in order to perform
an optional Flash Update. LED 302 will only appear if the key switch is in
the secure position. This signals the user that a Flash Update may be
initiated by moving the key switch to the service position. If the key is moved
to the service position LED 303 will be displayed, this signals the user to
press the reset button and select optional Flash Update.
Flash Utility ROM IOCC POST error (irrecoverable).
Flash Utility ROM standard I/O POST running.