Display Resource Attributes - IBM R/S6000 7012 300 Series Operator's Manual

Delete Resource from Resource List
Use this task to delete resources from the resource list
Note: Only resources that were previously detected by the diagnostics and have not been
deleted from the Diagnostic Test List are listed. If no resources are available to be
deleted, then none are listed.
Display Previous Diagnostic Results
Note: This service aid is not available when you load the diagnostics from a source other
than a disk drive or from a network.
Each time the diagnostics produce a service request number (SRN) to report a problem,
information about that problem is logged. The service representative can look at this log to
see which SRNs are recorded. This log also records the results of diagnostic tests that are
run in loop mode.
When this service aid is selected, information on the last problem logged is displayed. The
Page Down and Page Up keys can be used to look at information about previous problems.
This information is not from the error log maintained by the AIX operating system. This
information is stored in the /etc/lpp/diagnostics/data/*.dat file.

Display Resource Attributes

This task will display the Customized Device Attributes associated with a selected resource.
This task is similar to running the lsattr –E –l resource command.
Introduction to Tasks and Service Aids
4-9