IBM R/S6000 7012 300 Series Operator's Manual page 119

1. Set the power switches on the attached devices and the system unit to Off.
2. Unplug all attached devices and the system unit from power outlets.
3. Be sure to label all of the cables and cords connected to the rear of the system unit as
you disconnect them.
4. In the location you are moving to, the power outlets should be checked for correct wiring,
voltage, and grounding before attaching any of the devices or the system unit. See
"Checking Customer Outlets" in 7012 300 Series Installation and Service Guide .
5. Connect all signal cables to the devices before connecting any device or the system unit
to the power outlets.
8-2
Operator Guide