Connect The Harness To The Autoboom Valve; Connect The Harness To The Sensors - Raven ISO AutoBoom Case IH 3230 Installation Manual

C 6
HAPTER

CONNECT THE HARNESS TO THE AUTOBOOM VALVE

1. Locate the LEFT PRESS and RIGHT PRESS connectors on the harness cable (P/N 115-0230-032 or 115-0230-073).
2. Route the connectors to the AutoBoom valve (P/N 063-0131-124).
3. Connect the LEFT PRESS connector to Port G1 on the AutoBoom valve.
4. Connect the RIGHT PRESS connector to Port G4 on the AutoBoom valve.
5. Locate the LEFT SOLENOID and RIGHT SOLENOID connectors on the harness cable.
6. Connect the LEFT SOLENOID connector to Port 4A on the AutoBoom valve.
7. Connect the RIGHT SOLENOID connector to Port 4B on the AutoBoom valve.
8. Locate the LEFT PROP and RIGHT PROP connectors on the harness cable.
9. Connect the LEFT PROP connector to Port 5A on the AutoBoom valve.
10. Connect the RIGHT PROP connector to Port 13A on the AutoBoom valve.

CONNECT THE HARNESS TO THE SENSORS

FIGURE 2. Sensor Cables Connected
1. Locate the LEFT SENSOR (OUTER) connector on the AutoBoom harness cable (P/N 115-0230-032 or 115-0230-
073).
2. Connect the LEFT SENSOR (OUTER) connector to the sensor cable (P/N 115-0171-527 or 115-0230-051) installed
on the end of the left boom.
3. Locate the RIGHT SENSOR (OUTER) connector on the AutoBoom harness cable.
4. Connect the RIGHT SENSOR (OUTER) connector to the sensor cable (P/N 115-0171-527 or 115-0230-051)
installed on the end of the right boom.
5. If optional inside boom sensors are installed, repeat the steps above to connect the harness to the inner boom
sensors.
6. Locate the CENTER SENSOR cable and connect it directly to the center sensor.
28
ISO AutoBoom® Installation Manual for Case IH 3230, 3240, 3320, 3330, 3340, 4420, 4430, & 4440 (MY2010 &