Hirose Fx8 And Fx8C Series Information (Reference To Hirose Spec) - Advantech SOM-ETX Series Design Manual

7.1.1 Hirose FX8 and FX8C Series Information (reference to
Hirose Spec)
Product Specifications:
Table 7.2 Hirose FX8 and FX8C Series info
Rated Current 0.4A
Rating
Rated Voltage 100V AC
Table 7.3 Hirose FX8 and FX8C Series info
Item
1.Insulation Resistance
2. Withstand voltage
3. Contact Resistance
4. Vibration
5. Moisture Resistance
6. Temperature Cycle
7. Operating Life
8. Resistance to Soldering
heat
Notes:
1. Temperature rise included when energized.
2. This storage indicates a long-term storage state for the unused product
before the board mounted.
The operating temperature and humidity ranges are applied to the non-
energized state after the connector is installed in the board.
In addition, the operating temperature and humidity range can be set up to
+85c in the temporary storage state for a transportation period.
3. The above standards represent this series. Individual formal agreement
should be based on the "Specification".
120
Advantech SOM-ETX Design Guide
Operating Temperature
Range -55c~+85c
Operating Humidity Range
-40%~80%
Specification
1000M ohm min
Neither short or insulation
breakdown
45m ohm max.
Electrical discontinuity, 1µS
max.
Contact resistance:
55m ohm max.:
Insulation resistance:
100Mohm min
Contact resistance:
55m ohm max.:
Insulation resistance:
100Mohm min
Contact resistance: 55m ohm
max.
No resin area fusion to degrade
performance S
Chapter 7 Carrier Board Mechanical Design
Storage Temperature
Range -10c~+60c
Storage Humidity Range
40%~70%
Condition
Measured at 250V DC
300V AC for 1 minute
Measured at 100mA
10~55Hz and single amplitude
0.75mm in 3 directions for 10
cycles, respectively.
Exposed to temperature 40±2ç and
humidity 90~95% for 96 hours
-55ç: 30 minutes, 15~35ç: 2~3
minutes 5 cycles
-85ç: 30 minutes, 15~35ç: 2~3
minutes 5 cycles
50 cycles
Reflow: According to the
recommended temperature profile
oldering iron temperature: 300ç
for 3 seconds